88 DocuPrint N4525 Network Laser Printer
Control Panel Messages
0010
-DISK A fault condition has occurred.
■ Power OFF and Power ON the printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
0101
-DIMM1 A fault condition has occurred in DIMM1.
■ Power OFF the printer, remove and reinstall DIMM1, and Power ON the
printer.
■ If this code reappears at Power ON, replace DIMM1.
Refer to page 11 for location of the memory board.
0102
-DIMM2 A fault condition has occurred in DIMM2.
■ Power OFF the printer, remove and reinstall DIMM2, and Power ON the
printer.
■ If this code reappears at Power ON, replace DIMM2.
Refer to page 11 for location of the memory board.
0103
-DIMM3 A fault condition has occurred in DIMM3.
■ Power OFF the printer, remove and reinstall DIMM3, and Power ON the
printer.
■ If this code reappears at Power ON, replace DIMM3.
Refer to page 11 for location of the memory board.
1000
-IOT A fault condition has occurred.
■ Power OFF and Power ON the printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
2000
-XIE RAM A fault condition has occurred.
■ Power OFF and Power ON the printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
2010
-XIE PWPM A fault condition has occurred.
■ Power OFF and Power ON the printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
2020
-XIE VDMA A fault condition has occurred.
■ Power OFF and Power ON the printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
3000
-Token Ring A fault condition has occurred in the Token Ring interface.
■ Power OFF the printer, reseat the interface card, and then power ON the
printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
3000
-Serial A fault condition has occurred in the Serial interface.
■ Power OFF the printer, reseat the interface card, and then power ON the
printer.
■ If this code appears again at Power ON, contact your Customer Support
Center.
Error Description and corrective action