Filter
Top Products
Advanced Features and Troubleshooting Manual 27
Control Panel Menus
Sub Net Mask Sets the four byte Sub Net Mask address. (This menu item only appears if IP
Address Res is set to static.)
Values:
xxx.xxx.xxx.xxx
where xxx = 000 to 255
Note: Once the control panel shows
Sub Net Mask on the top line, use the
Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Default Gateway Sets the four byte Default Gateway address. (This menu item only appears if
IP Address Res is set to static.)
Values:
xxx.xxx.xxx.xxx
where xxx = 000 to 255
This item only appears if IP Address Res. is set to
Static.
Note: Once the control panel shows
Default Gateway on the top line,
use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Port Timeout Sets the time for determining when to end an incomplete print job and poll
the next port in the polling sequence. This menu item also causes an implicit
job end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
emulation functions associated with this action (e.g., formfeed, reset, etc.).
Values (in seconds):
5 - 300 (default is 30)
The value changes by 1 each time you press either Value key (labeled 3 or
7). Hold down either key to scroll quickly through the values.
Speed Sets the speed and half/full duplex mode of the 10/100BaseT Ethernet
interface. (This menu item does not appear when the 10Base2 Ethernet
interface is installed.)
Values:
Auto (default)
10/Half
10/Full
100/Half
100/Full
9100 Timeout Sets the timeout for the AppSocket Port 9100 communications protocol.
Values:
On (default)
Off
Ethernet Menu Items (cont'd.)