Filter
Top Products
Advanced Features and Troubleshooting Manual 91
Control Panel Messages
Enter Password
_xxx
Appears when using the Password Menu to print or delete secure and proof
jobs. Jobs Print or Jobs Delete.
■ Enter a valid 4-digit password using the control panel’s keys, then proceed
to print or delete the secure and proof jobs that have that password.
■ If you want to exit the Password menu, press the Menu keys (labeled 1 or 5).
To exit the menu system, press the On Line key (labeled 0).
Env. Feeder
Empty
The Envelope Feeder is empty.
■ Refill the Envelope feeder if it is to be used again.
Env. Feeder Fail
Power Off/On
The 100 Envelope Feeder has failed so printing from it cannot continue.
■ Power OFF the Printer, remove and re-install the Envelope Feeder, power
ON the printer.
■ If the Envelope Feeder still fails, contact your Customer Support Center.
Fan Failure
Power OFF NOW!
The fan is not working.
■ Power OFF the printer immediately and contact your Customer Support
Center.
Finisher Failure
Power Off/On
Problem in the Finisher.
■ Power OFF and ON the printer.
■ If the Finisher still fails, contact your Customer Support Center.
Flash Error
Format Flash
A Flash Memory error was found.
■ Format flash memory as per the instructions on page 54.
■ If the problem persists, contact your Customer Service Center.
Flushing...
Job name
Tells you that the PostScript print job could not be printed and is being parsed
out and discarded. This message remains on the display until the job being
flushed is complete, which may require additional data to be sent from the
host. This may require resubmitting the job to the printer.
Format Failed
Disk Locked
A problem occurred during disk formatting. Printing may continue, but use of
the disk is locked out.
■ Try reformatting the disk again or replace it.
Fuser Fan
Failure
The printer’s fuser fan has failed.
■ Power OFF and ON the printer.
■ If this message reappears, Power OFF the printer and contact your Customer
Support Center.
Fuser Failure
Power Off/On
The Fuser has failed; printing cannot resume.
■ Power OFF and Power ON the printer.
■ If the problem occurs again and you have just replaced the Fuser Cartridge,
reseat it.
■ If the problem occurs again and you have not replaced the maintenance kit,
it may be time to do so.
■ If the problem persists, contact your Customer Support Center.
Init Failed
Disk Locked
This disk cannot be initialized because it has been locked via a PJL command.
(It may be necessary to re-run the job without the lock command.)
Initializing... This message appears for a few seconds while the printer is initializing.
■ Wait.
Initializing…
Flash Memory
The printer is initializing the flash memory.
■ Wait.
Error Description and corrective action