Filter
Top Products
30 DocuPrint N4525 Network Laser Printer
Control Panel Menus
Default Gateway Sets the four byte Default Gateway address. (This menu item only appears if
IP Address Res is set to static.)
Values:
xxx.xxx.xxx.xxx
where xxx = 000 to 255
Note: Once the control panel shows
Default Gateway on the top line,
use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address
Port Timeout Sets the time for determining when to end an incomplete print job and poll
the next port in the polling sequence. The timeout also causes an implicit job
end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
emulation functions associated with this action (e.g., form feed, reset, etc.).
Values (in seconds):
5 - 300 (default is 60)
The value changes by 1 each time you press either Value key (labeled 3 or 7).
Hold down either key to scroll quickly through the values.
Source Routing Sets the source routing option.
Values:
Off (default)
All
Single/All
Single/Specific
Speed Sets the default ring speed of the Token Ring interface.
Values (in MBits):
4
16 (default)
LAA Sets the six byte Locally Administered Address.
Values:
xxxx.xxxx.xxxx
where xx = 00 to FF hexadecimal
where the range of xxxx.xxxx.xxxx is from
4000 0000 0000 through 7FFF FFFF FFFF.
Note: Once the control panel shows
LAA on the top line, use the
Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Token Ring Menu Items (cont'd.)