Filter
Top Products
Advanced Features and Troubleshooting Manual 53
Hard Disk Drive and Memory (DRAM and Flash ROM)
Hard Disk Drive and Memory (DRAM
and Flash ROM)
The optional hard drive in the printer significantly increases the amount of memory
available for processing jobs and storing downloaded information, including fonts, forms,
overlays (macros), secure jobs, and proof jobs.
The hard disk is used for:
■ Receiving raw, unprocessed data for secure jobs, proof jobs, and collated copy jobs.
■ Downloading fonts, forms, and overlays.
The optional flash memory may also be used for downloading fonts and macros.
Memory board (DIMM) locations
The following figure shows the location of memory boards (DIMMs) on the printer’s
controller board.
Note
The printer must be set to "Reset Mode" before the following two actions can be
performed. See page 35.
Hard disk initialization
The hard disk is preformatted and requires no initialization. You can return the disk to its
initial state (with no loaded fonts, overlays or secure jobs) by selecting the Initialize
Disk menu item from the Reset menu on the printer’s control panel.
DIMM 3
J6
DIMM 1
J4
DIMM 2
J5