Filter
Top Products
20 DocuPrint N4525 Network Laser Printer
Control Panel Menus
Output Timeout Specifies whether the printer waits after a bin is filled or directs output to an
alternate bin.
Values:
Off (printer waits after a bin is filled)
On (default - printer directs output to an alternate bin)
Output Offset Specifies whether output from jobs is offset in the Face-down Bin and
Finisher Output Bin (if installed).
Values:
Off (default - output not offset)
On (output offset)
Note: Output cannot be offset in the optional Face-up Bin.
Output Dest Sets the default paper output destination for PCL and PostScript jobs.
Values:
Face Down Bin (default)
Face Up Bin (only shown if optional Face-up Bin is installed and
enabled)
Finisher Bin (only shown if optional Finisher is installed)
Staple Mode Selects the default staple position. (Only appears when the Finisher is
installed.)
Values:
Off (default - no stapling)
Position 1 (Front)
Position 2 (Rear)
Dual (Two in middle)
Refer to the User Guide for information on stapling positions.
Punch Sets the default operation of the hole punch option. (Only appears when the
Finisher is installed.)
Values:
Off (default)
On
Print PS Errors Specifies whether to print an error page whenever a PostScript error occurs.
Values:
Off (default)
On
Power Saver Specifies the number of minutes of inactivity before the printer enters a
low-power state.
Values: (in minutes)
Off (never enter Power Saver mode)
15
30
60 (default)
90
120
180
System Menu Items (cont'd.)