Filter
Top Products
89
Backup battery
The lithium battery on the mainboard powers the real-time clock (RTC)
in the absence of power. When the battery starts to weaken, it loses
voltage, and the server settings stored in CMOS RAM in the RTC (for
example, the date and time) might be incorrect.
For a list of approved replacement batteries, contact your customer
service representative or dealer.
Warning! Danger of explosion if battery is incorrectly
replaced. Replace with only the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
Replacing the battery
1 Before proceeding, record your custom BIOS settings.
2 Disconnect the AC power cords from the power source or wall
outlets.
3 Turn off all peripheral devices connected to the server system.
4 Remove the following:
a Rear access panel - refer to page 44
b System board access panel - refer to page 51
c Memory board - refer to page 52
d Air baffle - refer to page 54
e Processor board - refer to page 55
5 Slide the battery in the direction shown in Figure 44, allowing the
battery to pop up.
AA G900 ug - EN.book Page 89 Wednesday, September 25, 2002 5:23 PM