Filter
Top Products
Appendix B: System management
182
2 In the PEM window, click Configure LAN.
3 If you want to require a password for remote access, enter the
password in the Enter New Password box and in the Verify New
Password box.
Passwords can be from 1 to 16 characters long, using any ASCII
character in the range [32-126]. To clear the passwords, leave both
boxes blank. (You can also clear the password by choosing Clear
LAN Password from the Options menu.)
4 From the LAN Access Mode list, select the remote access mode:
5 In the IP Setup box, choose either:
6 If you chose Static IP Setup in the previous step, fill in the IP
addressing boxes:
• Full Access A remote system can initiate a LAN connection
regardless of the state or health of the server.
• Restricted A remote system can initiate a LAN connection,
but cannot perform control operations such as
power down, reset, or front panel NMI.
• Disabled Remote systems are not allowed to initiate LAN
connections.
• DHCP The IP address for the server is automatically
assigned by the DHCP (dynamic host control
protocol) server on the network. The Host,
Gateway, and Subnet Mask boxes in the dialog
are ignored.
• Static Assign the IP address for the server using the
Host, Gateway, and Subnet Mask boxes in the
dialog.
•Host IP
Address
The IP address of this server.
• Gateway IP
Address
The IP address of the router for this server.
AA G900 ug - EN.book Page 182 Wednesday, September 25, 2002 5:23 PM