Filter
Top Products
3 Hardware configuration
50
Closing the front subchassis and rear
electronics bay
Caution! Before you close the front subchassis or electronics bay,
make sure no cables are pinched or otherwise obstructing the
front subchassis and rear electronics bay. Excessive cable stress or
chafing can cause cables to disconnect and connector pins to bend
or break the cable insulation.
To close the front subchassis and rear electronics bay
1 To close the rear electronics bay:
a Grasp the inside edge of the electronics bay and swing the
electronics bay into the main chassis.
b Connect all cables to the mainboard.
2 To close the front subchassis:
a Grasp the edge of the front subchassis.
b Depress and hold the spring clip (Figure 16, B) and swing the
front subchassis all the way into the main chassis.
Figure 16 - Closing the front subchassis and rear electronics bay
AA G900 ug - EN.book Page 50 Wednesday, September 25, 2002 5:23 PM