Filter
Top Products
1 System tour
8
Front control panel
The figure below describes the features of the front control panel.
Label Description Operation
A Power button To turn power on, press the power button
momentarily. If the system is in sleep state,
pressing the power button momentarily brings
the system out of the sleep state.
To turn power off, press and hold the power
button for more than four seconds. This
overrides ACPI mode.
B Sleep button To put a system supporting ACPI into sleep
mode (S1), press the sleep button momentarily.
To wake a system from sleep mode, press the
sleep button momentarily.
C Reset button To reset the system, press the reset button
momentarily.
To clear CMOS, press and hold the reset button
for at least four seconds, and then press the
power button. Release both the reset and
power buttons at the same time. The system
will power on and the CMOS will be reset.
D Chassis ID
button
Illuminates LEDs on both the front and rear of
the chassis, simplifying identification of the
chassis in a rack from the rear.
Figure 4 - Front control panel
AA G900 ug - EN.book Page 8 Wednesday, September 25, 2002 5:23 PM