Filter
Top Products
91
Front panel board
For a description of the features on the front panel board, see “Front
control panel” on page 8.
Installing the front panel board
1 Turn off power to the server and unplug the AC power cords from
the power source.
2 Remove the front access panel (refer to page 46).
3 Remove the fan modules and the foam fan baffle (refer to
page 88).
4 Disconnect the cables from the front panel board: the front panel
board ribbon cable, the intrusion switch cables, the USB cable, and
the serial port cable (refer to page 91).
One end of the front panel board is inserted into a slot in the front
subchassis and the other end is secured with a screw and a
snap-top standoff.
5 Remove the screw that secures the front panel board to the front
of the chassis.
6 Grasp the end of the board closest to the side of the chassis and
pull to disengage the board from the standoff.
7 Gently slide the board out of the slot in the front subchassis.
Figure 49 - Replacing the front panel board
AA G900 ug - EN.book Page 91 Wednesday, September 25, 2002 5:23 PM