Filter
Top Products
79
2 Remove the hard drive from its wrapper and place it on an
antistatic surface.
3 Record the new drive model and serial number in your equipment
log.
For a sample equipment log sheet, refer to page 197.
4 Place the drive in the carrier with the component side down.
5 Using the four screws removed earlier, attach the drive to the
carrier.
Label Description Label Description
A Air Baffle C Plastic rail
B Screw D Plastic rail
Figure 41 - Installing a SCSI hard disk drive in a carrier
AA G900 ug - EN.book Page 79 Wednesday, September 25, 2002 5:23 PM