Filter
Top Products
Appendix A: System rack installation
152
3
Removing the original tower bezel
You must remove the bezel that originally came with the tower
configuration of the Altos G900 server platform and, later in the
installation, replace it with the bezel from the rack conversion kit.
1 Move the chassis so the door hangs over the edge of your
workbench.
2 Open the door.
3 Ensure that the bezel lock is in the fully unlocked position. You
cannot remove the bezel unless it is unlocked.
4 Press on each of the eight plastic tabs (Figure 62, A) on the frame
of the bezel until all the tabs are free of their slots and then lift
the bezel off the chassis.
In the view shown below, there are three tabs on the left wall of
the frame, two on the top, two on the right, and one on the
bottom.
5 Secure the keys for the tower bezel.
It is recommended that the keys be taped to the inside of the
tower bezel for future use.
Figure 61 - Removing the left panel
AA G900 ug - EN.book Page 152 Wednesday, September 25, 2002 5:23 PM