Filter
Top Products
3 Hardware configuration
76
To remove a PCI add-in board from a non-hot-plug slot
1 Disconnect the AC power cords from the power source or wall
outlets.
2 Turn off all peripheral devices connected to the server system.
3 Remove the rear access panel (refer to page 44) and the system
board access panel (refer to page 51).
4 Release the latches on the front and rear retention mechanisms.
5 Grasp the board by the top edge or corners, carefully pull it out of
the connector, and slide it free of the retention bracket.
6 If you are installing a new board, follow the instructions on
page 75.
If you are not installing another PCI add-in board, continue with
the next step below.
7 Install a slot cover over the vacant slot in the back panel.
8 Install the system board access panel and the rear access panel.
For instructions, refer to page 52 and page 45 respectively.
9 Turn on any peripheral devices connected to the system.
10 Connect the power cord and turn on power to the server.
AA G900 ug - EN.book Page 76 Wednesday, September 25, 2002 5:23 PM