Filter
Top Products
Chapter 2 31
Installation
Installing the Hardware
Step 5: Observe the Power-On Sequence
n The Gateway now goes through its power-on, hardware self-test.
Verify that the hardware is working properly by looking at the LEDs
on the front panel of the Gateway.
n The green Power LED should now be illuminated and the red Fault
LED should be off. One or more of the yellow LAN LEDs may also
be flashing. Ignore the LAN LEDs at this time.
n The red Fault LED is illuminated briefly at power-on to verify its
operation. If the
Fault LED remains illuminated, a hardware fault was
found during the power-on, hardware self-test of the Gateway.
Please contact Agilent Technologies for instructions. Service is
required only if the
Fault LED remains illuminated.
n Once you have verified that the hardware is working properly (the
Gateway’s green
Power LED is illuminated), disconnect the
standard AC power cord from the power outlet (wall outlet).