Agilent Technologies E2050-90003 Switch User Manual


 
7
Safety Considerations
Product and Documentation Labels
A WARNING denotes a hazard that can cause injury or death. A CAUTION
denotes a hazard that can damage equipment or cause data loss. Do not
proceed beyond a WARNING or CAUTION notice until you understand the
hazardous conditions and have taken appropriate steps.
Grounding
The power module (Agilent 0950-2546 AC/DC Adapter) is a safety class I
product and has a protective earthing terminal. There must be an
uninterruptible safety earth ground from the main power source to the
product’s input wiring terminals, power cord, or power cord set. Whenever it
is likely that the protection has been impaired, disconnect the power cord
until the ground has been restored.
Servicing
There are no user-serviceable parts inside the E2050 LAN/GPIB Gateway or
its power module (AC/DC Adapter). Any servicing, adjustment,
maintenance, or repair must be performed by service-trained personnel
only. The power module does not have a power switch. The power cord is
intended to serve as the disconnect device. Make sure the power module is
installed near a wall outlet and is easily accessible.
Radio and Television Interference
This device has been verified to comply with FCC Rules Part 15. Operation
is subject to these two conditions: (1) this device may not cause radio
interference, and (2) this device must accept any interference received
(including interference that may cause undesired operation).
This equipment generates and uses radio frequency energy. If not installed
and used in accordance with this manual, it can cause interference to radio
and television communications. The rules with which it must comply afford
reasonable protection against such interference when it is used in most
locations.
However, there can be no guarantee that such interference will not occur in
a particular installation. If you think your device is causing interference, turn
off the system. If the radio or television reception does not improve, your
device is probably not causing the interference.