Filter
Top Products
Chapter 3 51
Configuration
Configuration Methods
For example, if you have not changed any of the configuration settings
previously, you will see the default configuration settings for the Gateway, as
follows. In this display, the hardware-addr: value is an example. Your
hardware-addr: value will be correct for your Gateway.
6 At the Telnet prompt (>), enter the configuration values you want to
change or set. You only need to specify the non-default values that
you want. The following information will help you set the values
correctly.
NOTE
On HP-UX 10.01, you may see the string Local flow control off at
the bottom of the screen. This will not affect the use of the Telnet utility to
configure the E2050.
Welcome to the E2050 LAN/GPIB Gateway configuration utility.
Commands
?
exit, quit
reboot
status
Show additional commands
Exit WITHOUT saving configuration changes
Save configuration changes and restart
Show the LAN/GPIB Gateway connection status
Configuration Parameters
hostname:
hardware-addr:
ip:
default-gw:
subnet-mask:
syslog-svr:
bootp:
lan-timeout:
io-timeout:
allow:
hpib-address:
hpib-name:
hpib-unit:
E2050
0800091A0E02
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
ON
0
120
*
21
hpib
7
# Internet domain name
# Ethernet station address
# Internet Protocol address
# Default subnet gateway IP address
# Network subnet mask
# Syslog server IP address
# Obtain config via BOOTP/TFTP
# LAN connect timeout in seconds
# Server I/O timeout in seconds
# IP allow list
# GPIB Address
# GPIB interface symbolic name
# GPIB logical unit number