Filter
Top Products
46 Chapter 3
Configuration
Configuration Methods
When you are connected to the Gateway, you will see general
information about the Telnet utility commands, as well as a listing of
the current configuration settings for this Gateway.
For example, if you have not changed any of the configuration
settings previously, you will see the default configuration settings for
the Gateway as shown. In this display, the hardware-addr: value
is an example. Your hardware-addr: value will be correct for your
Gateway.
7 Now you must turn on
Local Echo in the Terminal Preferences dialog
box so the Telnet utility will display your typed input. From the menu
at the top of the Telnet window, select
Terminal | Preferences. The
Terminal Preferences dialog box is displayed.
8 Click the checkbox next to
Local Echo to turn it on. A checkmark is
displayed in the checkbox.
Local Echo is now set on.
9Click
OK to close the Terminal Preferences dialog box.
Welcome to the E2050 LAN/GPIB Gateway configuration utility.
Commands
?
exit, quit
reboot
status
Show additional commands
Exit WITHOUT saving configuration changes
Save configuration changes and restart
Show the LAN/GPIB Gateway connection status
Configuration Parameters
hostname:
hardware-addr:
ip:
default-gw:
subnet-mask:
syslog-svr:
bootp:
lan-timeout:
io-timeout:
allow:
hpib-address:
hpib-name:
hpib-unit:
E2050
0800091A0E02
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
ON
0
120
*
21
hpib
7
# Internet domain name
# Ethernet station address
# Internet Protocol address
# Default subnet gateway IP address
# Network subnet mask
# Syslog server IP address
# Obtain config via BOOTP/TFTP
# LAN connect timeout in seconds
# Server I/O timeout in seconds
# IP allow list
# GPIB Address
# GPIB interface symbolic name
# GPIB logical unit number