Filter
Top Products
62 Chapter 3
Configuration
Configuration Methods
At the client system, type: ping hostname (or) IP_address Return
For example, using a Gateway’s hostname:
ping E2050.agilent.com
Return
Or, using a Gateway’s IP address:
ping 156.140.4.249
Return
You should get a response from the ping command that is similar
to the following, where each line after the PING line is an example
of a packet successfully reaching the Gateway from the client
system.If your ping response is similar to the following, the
Gateway has been configured successfully.
PING E2050.agilent.com: 64 byte packets
64 bytes from 128.10.0.3: icmp_seq=0. time=3. ms
64 bytes from 128.10.0.3: icmp_seq=1. time=3. ms
64 bytes from 128.10.0.3: icmp_seq=2. time=2. ms
.
.
.
If, after several seconds, ping does not print any lines, use
Ctrl+C
to kill ping. The ping will then report on what it found. A response
similar to the following indicates the client was unable to contact the
Gateway and there may be some problem with the Gateway’s
configuration or the network itself. If you have trouble configuring the
Gateway or want to verify that the configuration is correct, see
Chapter 5.
----E2050.agilent.com PING Statistics----
4 packets transmitted, 0 packets received, 100%
packet loss