Filter
Top Products
Chapter 5 91
Troubleshooting
Troubleshooting Gateway Configuration
Changing the Configuration Method
If you want to change the configuration method used for the Gateway, you
can take one of three following actions. However, for Windows 95/98/Me/
2000/NT client systems, you must use the Telnet configuration method.
Neither the BOOTP nor the BOOTP with TFTP configuration methods are
available on Windows client systems. After you change the configuration
method, see Chapter 3 to configure the Gateway to the new method.
1 Telnet to the Gateway, modify the bootp: ON/OFF value and then
use the Telnet reboot command.
2 Telnet to the Gateway and then do a Telnet factory-reset
command. This changes the configuration values the default values
and reboots the Gateway. This also sets the bootp: ON/OFF value
to the default ON value. For HP-UX client systems, you can now use
the BOOTP or the BOOTP with TFTP configuration method.
3 Press the
Config Preset button on the back panel of the LAN/GPIB
Gateway at the same time as you power-on the Gateway. This
changes all configuration values to the default values. This includes
setting the bootp: ON/OFF value to the default ON value. For
HP-UX client systems, you can now use the BOOTP or the BOOTP
with TFTP configuration method.
CAUTION
Any client operations in progress and client connections will be
terminated by the reboot command.
CAUTION
Any client operations in progress and client connections will be
terminated by the factory-reset command when it reboots the
Gateway.