Filter
Top Products
76 Chapter 4
Administration
Configuring the Gateway
To change the configuration method used for the Gateway, you can modify
the bootp: ON/OFF Telnet configuration value or you can press the
Config
Preset
button. Once you have changed the configuration method, follow the
procedures in Chapter 3 to configure the Gateway via the new method.
To modify the bootp: ON/OFF Telnet configuration value:
1 To change to the Telnet configuration method, at the Telnet prompt
(>), type: bootp: OFF
2 To change to BOOTP or BOOTP with TFTP configuration method,
at the Telnet prompt (>), type bootp: ON
3 After you have modified the bootp: ON/OFF value, execute the
reboot Telnet command to save the new configuration setting and
reboot the Gateway.
4 Execute a Telnet factory-reset command. This changes the
configuration values to the default values and reboots the Gateway.
This will set the bootp: ON/OFF value to the default ON value.
You may now use the BOOTP or the BOOTP with TFTP
configuration method.
NOTE
The bootp: ON/OFF configuration value in the Telnet utility is
automatically set to
OFF if the IP address is changed via the Telnet utility.
CAUTION
Any client operations in progress and client connections will be
terminated by the reboot command when it reboots the Gateway.
CAUTION
Any client operations in progress and client connections will be
terminated by the factory-reset command when it reboots the
Gateway.