Filter
Top Products
52 Chapter 3
Configuration
Configuration Methods
The following table lists the configuration values you can set using
Telnet. The information following the table explains the syntax you
should use and provides reminders to help you to change or set the
configuration values correctly.
For each configuration value to change or set, use the syntax:
Telnet_command: value Return
For example, to set the IP address value of 156.140.222.201 for
the Gateway, enter: ip: 156.140.222.201
Return
If you make a mistake, re-enter the correct configuration value you
want. To do this, use the same syntax as before to re-enter the
value (Telnet_command: value
Return).
NOTE
By using the Telnet configuration method, the LAN hardware address
(hardware-addr:) value is automatically set to the correct hardware
address for this LAN/GPIB Gateway. Do not change the hardware
address value via Telnet. Its value in the Telnet configuration table is for
information purposes only.
Configuration Value Telnet Command Default Value
Hostname hostname: E2050
IP Address ip: 192.0.0.192
Default Subnet Gateway Address gateway: 0.0.0.0
Subnet Mask subnet-mask: 0.0.0.0
Syslog Server Address syslog-svr: 0.0.0.0
BOOTP bootp: ON
LAN Timeout lan-timeout: 0
I/O Timeout io-timeout: 120
IP Allow List allow: * (All allowed)
GPIB Address hpib-address: 21
GPIB Interface Name hpib-name: hpib
GPIB Logical Unit hpib-unit: 7