Filter
Top Products
48 Chapter 3
Configuration
Configuration Methods
For each configuration value to change or set, use the syntax:
Telnet_command: value
Enter. For example, to set the IP address
value of 156.140.222.201 for the Gateway, enter:
ip: 156.140.222.201
Enter
If you make a mistake, re-enter the correct configuration value you
want. To do this, use the same syntax as before to re-enter the
value (Telnet_command: value
Enter).
If you want to exit without saving any of the configuration values you
have changed or set, enter either exit
Enter or quit Enter. You
can then re-enter the Telnet configuration utility starting with Step 6.
Any time during the Telnet session, you can enter config
Enter to
view the current configuration settings. Any time during the Telnet
session, you can enter ?
Enter for a list of available commands you
can use in the Telnet utility.
11 When you have changed or set all the configuration values you want
for the Gateway, type reboot
Enter. Then, type y Enter to confirm
your changes. Rebooting activates the configuration values you
have set for the Gateway.
12 After you have rebooted the Gateway, test that the Gateway has
been successfully configured by using the ping command. This
command allows you to test general network connectivity between
your client computer system and the LAN/GPIB Gateway. At the
client system, type: ping hostname (or) IP_address
Enter
For example, using a Gateway’s hostname:
ping E2050.agilent.com
Enter
Or, using a Gateway’s IP address:
ping 156.140.4.249
Enter
CAUTION
If you are reconfiguring the Gateway, any client operations in progress
and client connections will be terminated by the reboot command.