Filter
Top Products
Setting Up Video Endpoints
128 Avaya Video Telephony Solution Networking Guide
Configure a Polycom PathNavigator/SE200 Gatekeeper
This section describes how to configure a Polycom PathNavigator/SE200 Gatekeeper.
Checklist
When setting up these systems, you will need to know the following information:
● the IP codec sets you want to use
● the IP network regions you want use
● the IP address of the IP board for the gatekeeper
Configuration Procedures
To configure a Polycom PathNavigator gatekeeper, you must perform the following steps:
1. Add an entry in the IP Node Names for the PathNavigator/SE200.
2. Add a signaling group for the PathNavigator.
3. Add a trunk group for the PathNavigator.
4. Modify the signaling group for the PathNavigator.
5. Create a route pattern to the PathNavigator.
6. Configure the PathNavigator.
Procedure 1: Add an Entry in the IP Node Names for the PathNavigator/
SE200
To add an entry in the IP Node Names form for the PathNavigator/SE200 system:
1. Use the change node-names ip command to access the IP Node Names form.
2. In the Name field, enter a name for the PathNavigator/SE200 system.
3. In the corresponding IP Address field, enter the IP address of the IP board for the
PathNavigator/SE200 system.