Filter
Top Products
Configure Polycom VSX/HDX Series Video Conferencing Systems and V500/V700 Video Calling Systems
Issue 3 January 2008 63
j. Use the change station xx command (where xx is the first station you added for the
Polycom system) to set Hunt-to Station to the second station you added for the Polycom
system.
k. Use the change station xx command (where xx is the second station you added for the
Polycom system) to set Hunt-to Station to the third station you added for the Polycom
system.
l. Use the change station xx command (where xx is the third station you added for the
Polycom system) to set Hunt-to Station to the first station you added for the Polycom
system. All three stations must be in a circular hunt.
Note:
Note: If you added more than three stations for the Polycom system, use the change
station xx command to set Hunt-to Station for each station. All of the stations
you add must be in a circular hunt.
8. Repeat Steps 1 through 7 for each Polycom system.
Procedure 4: Configure the Polycom System
To configure the Polycom system:
1. Install the Polycom system and connect it to your network.
2. Upgrade the Polycom system software (if necessary).
3. Using a web browser, access the Polycom home page for the unit, and select Admin
Settings>Network>IP Network.
4. Select the Enable IP H.323 check box.
5. Select the Display H.323 Extension check box.
6. In the H.323 Extension (E.164) box, enter the station number you specified for this system
on the Avaya Communication Manager system.
7. From the Use Gatekeeper box, select Specify with PIN.
8. In the Gatekeeper IP Address box, enter the IP address of the CLAN or PCLAN followed by
:1719 (to specify the correct port to use).
9. In the Authentication PIN box, enter the security code you entered in Procedure 4.
10. In the Number box in the Gateway area, enter the extension you specified.
11. Select the Enabled PVEC check box.
12. In the Type of Service box in the Quality of Service area, select the appropriate setting. Both
IP Precedence and Diffserve are supported. Contact your Network Administrator for this
information.
13. In the Type of Service Value boxes (Video, Audio, and Far End Camera Control), enter the
QoS values for the IP Network Region settings in which the VSX station belongs.
14. Select the Dynamic Bandwidth check box.