Filter
Top Products
Configure a Polycom RMX Series Video Conferencing Bridge Platform
Issue 3 January 2008 65
Configure a Polycom RMX Series Video Conferencing
Bridge Platform
This section describes how to configure a Polycom RMX series video conferencing bridge
platform for use with an Avaya server.
Checklist
When setting up these systems, you will need to know the following information:
● the IP codec sets you want to use
● the IP network regions you want use
● the IP address of the IP board for the RMX system
● the IP address of the CLAN
Note:
Note: Make sure you have the RMX Installation and Configuration guide available when
you configure the RMX.
Configuration Procedures
To configure a Polycom RMX video conferencing bridge platform, you must perform the
following steps:
1. Add an entry in the IP Node Names for the RMX system.
2. Add a two-way trunk group for the RMX system.
3. Add a signaling group for the RMX system.
4. Add members to the two-way trunk group for the RMX system.
5. Create a route pattern for the trunk group.
6. Configure the RMX system.