Filter
Top Products
Setting Up Video Endpoints
56 Avaya Video Telephony Solution Networking Guide
Procedure 3: Add a Video-Enabled Avaya IP Softphone Station
To add a video-enabled Avaya IP Softphone station:
1. Perform one of the following steps:
● If you want to add a new station that will use Avaya IP Softphone, use the add station
command.
● If you want to modify an existing station that will use Avaya IP Softphone, use the
change station xxxx (where xxxx is the number of the station you want to modify)
command.
The Station form appears.
Figure 7: Example of Page 1 of the Station Form
2. Enter the appropriate information for this station.
3. Set IP Softphone to y.
4. Set IP Video Softphone to y.
5. If you want this station to be able to make priority video calls, make sure you select a COS
level that has Priority Video Calling enabled. (See Procedure 2.)
6. Repeat Steps 1 through 5 for each video-enabled Avaya IP Softphone endpoint you want to
configure.