Filter
Top Products
Configure a Polycom PathNavigator/SE200 Gatekeeper
Issue 3 January 2008 129
Procedure 2: Add a Signaling Group for the PathNavigator/SE200
To add a signaling group for the PathNavigator/SE200 system:
1. Use the add signaling-group xx command (where xx is the chosen signaling group) to
access the Signaling Group form.
The Signaling Group form appears.
2. Set Group Type to h.323.
3. Set IP Video to y.
4. Set Priority Video. If you want all incoming calls to receive priority video transmissions,
select y.
5. Set Near-end Listen Port to 1719.
6. Set LRQ Required to y.
7. Set Far-end Node Name to the name you entered for the PathNavigator/SE200 system.
8. Set Far-end Listen Port to 1719.
9. Set the Far-end Network Region to the appropriate IP network region.
10. Set Direct IP-IP Audio Connections to y.
11. Set IP Audio Hairpinning to y.
Procedure 3: Add a Trunk Group for the PathNavigator/SE200
To add a trunk group for the PathNavigator/SE200 system:
1. Use the add trunk-group xx command (where xx is the chosen trunk group) to access the
Trunk Group form.
The Trunk Group form appears.
2. Set Group Type to isdn.
3. Set Carrier Medium to IP.
4. Go to page 5 of the Trunk Group form.
5. Add members to the trunk group.
Procedure 4: Modify the Signaling Group
To modify the signaling group for the PathNavigator system:
1. Use the change signaling-group xx command (where xx is the signaling group you
added) to access the Signaling Group form.
The Signaling Group form appears.
2. Set Trunk Group for Channel Selection to the trunk group you just added.