Filter
Top Products
Design and Deployment Checklist
30 Avaya Video Telephony Solution Networking Guide
Question 4: Is the incoming trunk group for the Polycom MGC configured
correctly in the change trunk-group form?
On Trunk group page 1, “Direction” must be incoming.
On Trunk group page 2, “Disconnect Supervision – In?” must be y to allow transfer of
MGC-initiated calls to other trunks.
Yes.
No. Expect trunk transfer failure.
Question 5: Is there only one incoming trunk group per Polycom MGC?
Yes.
No. Read this guide or the quick setup guide.
Question 6: Does the Polycom MGC have additional IP boards?
Yes. For board redundancy, administer a second outgoing trunk group for the second to
“nth” IP boards.
No. Only one outgoing trunk group is required.
Question 7: Is the outgoing signaling group to the MGC configured
correctly?
“LRQ Required?” must be y.
“Near end Listen Port” must be 1719.
“Far end Listen Port” must be 1719.
“Trunk Group for Channel Selection” must be clear.
Yes.
No. Expect call failures or intermittent call failures, or shuffling that shuts down video.