Filter
Top Products
Configure a Polycom RMX Series Video Conferencing Bridge Platform
Issue 3 January 2008 69
Procedure 4: Add Members to the Two-Way Trunk Group
To add members to the two-way trunk group:
1. Use the change trunk-group xx command (where xx is the incoming trunk group you
added) to access the Trunk Group form.
The Trunk Group form appears.
2. Go to page 5 of the Trunk Group form.
Page 5 of the Trunk Group form appears.
Figure 14: Example of Page 5 of the Trunk Group Form
3. Add members to the trunk group. The number of members depends on the maximum
simultaneous calls an RMX supports.