Filter
Top Products
Configure Ad-hoc Video Conferencing for a Polycom RMX Series Video Conferencing Bridge Platform
Issue 3 January 2008 71
Configure Ad-hoc Video Conferencing for a Polycom RMX
Series Video Conferencing Bridge Platform
This section describes how to configure Ad-hoc video conferencing for a Polycom RMX series
video conferencing bridge platform.
Checklist
When setting up Ad-hoc conferencing on a Polycom RMX system, you will need to know the
following information:
● the IP codec sets you want to use
● the IP network regions you want use
● the IP address of the IP board for the RMX system
● the IP address of the CLAN
Note:
Note: Make sure you have the RMX Installation and Configuration guide available when
you configure the RMX.
Configuration Procedures
To configure Ad-hoc conferencing, you must perform the following steps:
1. Configure the RMX for use with an Avaya server.
2. Determine the maximum number of Ad-hoc video conferencing ports your voice system
supports.
3. Configure the Class of Service for Ad-hoc video conferencing.
4. Configure a video bridge.
5. Configure the RMX system for Ad-hoc conferencing.