Filter
Top Products
CHAPTER 10 BANYAN VINES NETWORK CONFIGURATION
10-7
Print Server Configuration Using the Print
Server Console
As an alternative to BRadmin, you may use the print server console to configure the
print server. The steps are as follows:
1.
Connect to the print server console using TELNET, NCP, BRCONFIG
Execute some or all of the commands detailed below (you must minimally
enter the StreetTalk login name of the print server and associate one of the
print server services with the StreetTalk name of a print queue).
SET BAnyan LOgin loginname
Sets StreetTalk login name of print server.
SET BAnyan PAssword password
Sets login password of print server. The password (if any) must match the password
you specified in step A-3.
SET SERVIce service STreettalk queuename
Enables the Banyan protocol on the specified Brother print server service and
associates this service with the StreetTalk name of a given print queue on the VINES
file server. Type SHOW SERVICE to see a list of the available services (if in doubt,
use BINARY_P1).
SET BAnyan HOp nn
Sets number of hops between the Brother print server and the Banyan file server. The
default value is 2, which is adequate for most sites, but you will need to change this
value if the file server is more than two hops away from the print server.
When you have finished entering commands, type EXIT to exit the remote console
and cause the commands to take effect.