Filter
Top Products
APPENDIX
APPENDIX-2
TELNET
To connect to the print server using TELNET on UNIX, Windows NT, or most other
TCP/IP systems, type: TELNET ipaddress at the command prompt of the system
prompt, where ipaddress is the IP address of the print server. When you are
connected, push RETURN or ENTER to get the "#" prompt, enter the password
"access" (the password will not appear on the screen), and type anything in response
to the Enter Username> prompt. When you see the Local> prompt, you are ready to
enter commands.
Enter HELP at the command prompt for a list of supported commands. For a
complete list of supported commands along with an explanation of them, please refer
to the file commands.pdf
BRCONFIG
Brother BRCONFIG utility runs on the DOS system prompt and is installed with
BRAdmin. To connect the print server using the Brother BRCONFIG NetWare
utility, Choose the BRCONFIG utility from the Brother BRAdmin utilities menu or
insert the Brother BRAdmin utility diskette into Drive A and type: A:BRCONFIG at
the DOS system prompt. If you have only one print server, you will be immediately
connected to that server. If you have more than one print server, you will be given a
list of available print servers. Type the number of the print server to which you wish
to connect. When you are connected, enter the password "access" (the password will
not appear on the screen) at the "#" prompt, and type anything in response to the
Enter Username> prompt. When you get the Local> prompt, you are ready to enter
commands. To use BRCONFIG, a Novell Server (running the IPX protocol) is
necessary and an active connection must be made to the server.
Enter HELP at the command prompt for a list of supported commands. For a
complete list of supported commands along with an explanation of them, please refer
to the file commands.pdf
For a list of commands and for information about upgrading firmware, please refer to
the chapter: commands.pdf on the CD-ROM that is supplied with the product CD.