Filter
Top Products
CHAPTER 6 NOVELL NETWARE PRINTING
6-15
18.
Execute the BRCONFIG from the Windows menu or insert the Brother Print
Server Configuration Utility diskette in Drive A: of your PC and type:
A:BRCONFIG.
Select the print server from the list of print servers. When you get the
message that the print server is connected, press the ENTER key and type
the default password of "access" in response to the "#" prompt (the password
will not echo), and then press the ENTER key again in response to the
ENTER Username> prompt. When you get the Local> prompt, type:
SET SERVICE service TREE tree
SET SERVICE service CONTEXT Context
•
Where tree is the NDS tree name.
•
Where context is the name of context where the print server resides.
•
Service is the name of the service assigned by NetWare print server
name (where the default services are BRN_xxxxxx_P1 or
BRO_xxxxxx_P1 for the Brother printer, where "xxxxxx" is the last six
digits of the Ethernet address (MAC address).
•
You can also enter the TREE and CONTEXT name using your web
browser by connecting to the Brother print server using the TCP/IP
protocol and selecting the NetWare protocol configuration.
19.
Use the BRCONFIG command or TELNET command: SET NETWARE
RESCAN to force the print server to rescan for file servers, or power cycle
the printer.
The same services assigned by NetWare print server names cannot be used for both
queue server mode and remote printer mode.
The same service assigned by NetWare print server cannot be used for both queue
server mode and remote printer mode. If you want to enable remote printer
capabilities on a service other than the default NetWare service, you must define new
services that are enabled for NetWare and for the desired port. Refer to Appendix B
in this manual for information on how to do this.