Filter
Top Products
CHAPTER 1 UNIX PRINTING
1-11
DEC TCP/IP Servers for VMS(UCX)
You need to run the sys$system:ucx:$lprsetup command, specify a printer name, and
then enter the print server IP address as the remote system name. Specify one of the
print server services (see beginning of this section for options) as the remote system
printer name (accept the defaults for other questions).
TGV's Multinet
TGV's Multinet requires you to run the MULTINET CONFIGURE /PRINTERS
command, then use the ADD command to add a printer, specifying the print server IP
address, a protocol type of LPD, and one of the service options described at the
beginning of this section as the remote print queue.
Wollongong's PATHWAY
First make sure that you have the Access option with lpd enabled. Then enter the
print server name and IP address in the TWG$TCP:[NETDIST.ETC]HOSTS file, run
the LPGEN program, and execute the command: add
queue/rmachine=prnservername/rprinter=prnserverservice, where queue is the name
of the queue, prnservername is the print server name from the hosts file, and
prnserverservice is the print server service name.
IBM/AS4000
To use a Brother print server with an IBM AS/400 running IBM’s TCP/IP gateways
services for OS/400 (the OS/400 system must be v3.1 or later)
Use the CFGTCP command at your OS/400 prompt to add the print server’s TCP/IP
address to the AS/400 host table.
Use the following one-line OS/400 command to create the LPD queue:
CRTOUTQ OUTQ(<queuename> RMSTSYS
(*INTNETADR) RMTPRTO(<service>)
AUTOSTRWTR(1) CNNTYPE(*IP) DESTTYPE (*OTHER)
MFRTYPMDL (<driver>)
INTNETADR(‘<ipaddress>’) TEXT
(‘<description>’)
where <queuename> is the new AS/400 print queue name, <service> is the print server
service name,
BINARY_P1 or TEXT_P1
, <driver> is the OS/400 printer driver name
(*HP4 is recommended if in doubt), and <ipaddress> is the IP address of the print
server.Note that the IP address and description must be enclosed in single quotes.