Filter
Top Products
CHAPTER 13 TROUBLESHOOTING
13-8
6.
If you are having trouble printing more than one job at a time, try increasing
the IP timeout using the SET IP TIMEOUT command or using BRAdmin.
7.
If text or PCL jobs are run together, try setting the service (remote printer)
with EOT set to string number 2 (<ESC>E). For example:
SET SERVICE BRN_xxxxxx_P1 EOT 2
NC-2000 series print servers use service names that begin with
BRO_xxxxxx_P1. The above line on a NC-2010h or a NC-2100h would be
SET SERVICE BRO_xxxxxx_P1 EOT 2
8.
If PostScript jobs fail to print or are run together, try setting the service
(remote printer) with EOT set to string number 3 (control-D). For example:
SET SERVICE BRN_xxxxxx_P1 EOT 3
NC-2000 series print servers use service names that begin with
BRO_xxxxxx_P1. The above line on a NC-2010h or a NC-2100h would be
SET SERVICE BRO_xxxxxx_P1 EOT 3
9.
If the lines of a text file are staggered, make sure that you have specified a
remote printer (rp) name of TEXT in your /etc/printcap file.
10.
If you are using Sun Solaris V2.4 or earlier, there is a bug which causes long
print jobs to fail when using a print server. If you are having trouble printing
long jobs (over 1MB), add the line mx#0 to your etc/printcap file entry.
11.
If you cannot print from DEC TCP/IP Service for VMS (UCX), make sure
that you have version 2.0B or later of this software, because earlier versions
will not work with Brother print servers.