Filter
Top Products
CHAPTER 9 NOVELL NETWARE PRINTING
9-11
9. Click on the button to select the print queue volume. Change the
directory context if necessary, then select the desired volume (Objects)
and click OK. Click Create to create the print queue.
10. Change context if required and then double click the name of the printer
you created previously.
11. Click Assignments and then Add.
12. Change context if necessary and select the print queue you created. Click
OK and then OK again, and then exit NWADMIN.
13. Start the appropriate BRAdmin application, and select the correct Print /
Fax server you wish to configure (by default, the node names will begin
with BRN_xxxxxx_P1 )
You can find the NetWare server name and MAC address by printing out the
FAX/MFC’s configuration page. Refer to the Quick Network Setup Guide for
information on how to print the configuration page on your Print / Fax server.
14. Double click the appropriate Print / Fax server. You will be prompted
for a password, the default password is "access".
15. Now select the NetWare tab.
16. Select Remote Printer as the Operating Mode, select the name of your
PSERVER NLM as the Print / Fax server Name and select the number
of the printer from step 6 as the Printer Number.
The same service assigned by NetWare Print / Fax server cannot be used for both
queue server mode and remote printer mode. If you want to enable remote printer
capabilities on a service other than the default NetWare service, you must define
new services that are enabled for NetWare and for the desired port. Refer to
Appendix B in this manual for information on how to do this.
17. Click OK. And exit BRAdmin.
You must now unload the PSERVER NLM from your NetWare file server
console and then reload it in order for the changes to take effect.
As an alternative to Brother's BRAdmin application or the Novell NWADMIN
application, you can use the standard Novell PCONSOLE utility in conjunction
with Brother's BRCONFIG program to set up your print queues. BRCONFIG
program will be installed at the same time when you install the BRAdmin and
you can find the BRCONFIG in the menu "Start/Program/Brother BRAdmin
utilities". Otherwise you can find it on the CD-ROM supplied with your
FAX/MFC. Note that if desired, you may use a WWW browser or TELNET
utility - instead of the BRCONFIG utility).