Brother QL-500 Printer User Manual


 
USER’S GUIDE
4–18
Operation Example: Selecting the Parallel Interface
For this session, select the parallel interface manually as follows:
1. Press the SEL switch to set the printer off-line.
2. Press the MODE switch.
The display shows the first menu.
INTERFACE MODE
3. Press the SET switch.
When you enter the interface mode, the display first shows the current
interface with the asterisk.
I/F=AUTO *
4. Press the or switch until the desired interface appears on the
display.
I/F=PARALLEL
Display Message Interface Mode
I/F=PARALLEL Parallel interface
I/F=RS-232C Serial interface
I/F=USB Universal Serial Bus interface
I/F=OPTION Optional interface for MIO card
I/F=AUTO Auto interface selection
Note
The optional interface is available only when a commercial MIO
compatible sharing/network card has been installed.
5. Press the SET switch to make the displayed selection effective.
An asterisk appears at the end of the display for a short time. Then the
printer automatically exits from the setting menu to the interface menu.
INTERFACE MODE