Filter
Top Products
CHAPTER 4 CONTROL PANEL
4–11
MODE Switch Settings in HP-GL Mode
The following table shows all the selections you can make with the
MODE switch in the HP-GL mode.
✒ Note
The mode menus and settings that can appear vary according to the
current emulation mode, printer status, and any options that may be
installed in the printer.
Mode Menu Setting Menu Sub-Setting Menu
Setting
INTERFACE MODE
Same as LaserJet 4 Mode
(See 4-15.)
FORMAT MODE
(See 4-18.)
PAGE FORMAT MODE PAPER=LETTER
(For 110/120V mode)
LETTER, LEGAL, A4, A5,
A6, B5, B6, EXECUTIVE,
COM10, MONARCH, C5,
and DL
X OFFSET= 0
-500 (left) to +500 (right)
dots
Y OFFSET= 0
-500 (up) to +500 (down)
dots
exit
Exit to PAGE FORMAT
MODE
GRAPHICS MODE PEN SETTING
SETTING=PEN1
PEN1 to 6
(Set size and gray
percentage for the
selected pen. )
SIZE #=3 dots 1 to 10 dots (pen size in
dots)
(# is the selected pen
number. )
GRAY #=100% 15, 30, 45, 75, 90, or
100%
(# is the selected pen
number. )
exit
Exit to SETTING=PEN1–
6
exit
Exit to GRAPHICS MODE
CHARACTER SET
STANDARD SET
Standard character set
ANSI ASCII
See character sets on
page 4-26.
ALTERNATE SET
Alternate character set
ANSI ASCII
See character sets on
page 4-26.
exit
Exit to GRAPHICS MODE
exit
Exit to FORMAT MODE
R
ESOLUTION MODE RESOLUTION RESOLUTION=600 300 or 600 dpi
(
See 4-26.) exit Exit to RESOLUTION MODE