Filter
Top Products
CHAPTER 4 CONTROL PANEL
4–29
CARD OPERATION
✒ Notes
• BE SURE TO TURN OFF THE PRINTER POWER SWITCH
BEFORE INSTALLING OR REMOVING THE FLASH MEMORY
CARD OR HDD CARD, OR THE CARD WILL BE DAMAGED.
• The settings in this mode menu are effective only when you have
installed a flash memory card or a HDD card in the card slot of the
printer and you have selected the HP LaserJet 4 or HP-GL mode.
They do not appear when the printer has no card or is in any other
emulation mode.
• If you turn the printer off or remove the flash memory card or the
HDD card while data is being written onto or deleted from the
card, all the data on the card may be lost.
• If the write protect switch of the flash memory card or the HDD
card is on, this mode menu does not appear.
Be sure to install a commercial flash memory card or a HDD card in
the upper card slot of the printer. For installation, see “FONT
CARTRIDGE/CARD, FLASH MEMORY/HDD CARD” in Chapter 5.
When you are in this mode menu, you can save macros and fonts in
the installed flash memory card or the HDD card.
The sub-setting menus displayed in this mode menu vary according to
the state of the installed card.
When the installed card is not formatted:
When you enter this mode menu with the flash memory card or the
HDD card installed but not formatted by this printer, you must first
format the card.
Display Message Card Operation
FORMAT CARD Format a new flash memory card or HDD
card.
exit Exit to CARD OPERATION
When the display shows “FORMAT CARD,” press the SET switch to
format the installed card.
After the printer finishes formatting the card, you exit to the “CARD
OPERATION” menu.