Brother HL-1260 Printer User Manual


 
USER’S GUIDE
5–2
FONT CARTRIDGE/CARD, FLASH MEMORY/HDD CARD
Installing a Font Cartridge/Card, Flash Memory Card and HDD
Card
This printer has one slot for an optional font cartridge and one slot for an
optional font card, flash memory card or HDD card.
If you install the optional font cartridge/card, you can use the fonts stored in
them as well as resident fonts. For optional font cartridges/cards, consult
the dealer where you purchased the printer.
If you install the optional flash memory card or HDD card, you can save
macros and fonts on it. For flash memory card and HDD card operation and
information, see “CARD OPERATION” in Chapter 4.
Notes
Do not install or remove cards with the printer power on, or you may
lose all data from the card, or may seriously damage the card if you do
this.
For more information about the cards, consult the dealer where you
purchased the printer.
Follow these steps to install or remove a cartridge/card:
1.Make sure that the printer is turned off.
If the printer is turned on, be sure to press the SEL switch to set the
printer off-line. If data remains in the printer memory, the DATA lamp
stays on. Press the FORM FEED switch to print out the remaining data,
then the DATA lamp goes off. Turn off the printer.
2.Insert the font card, flash memory card or HDD card into the upper slot
A and the font cartridge into the lower slot B with the cartridge/card
label facing to the left. Make sure they fit securely.
To remove the cartridge/card, pull them out of the slot with the printer
turned off.