Filter
Top Products
IV - 10
1.12 Paper Feed Chassis Unit
(1) Pull out the unit by loosening the 8 screws (4 screws for front and 4 screws for bottom).
(2) Remove the paper hold front and paper hold rear by pinching the pawl of the paper hold front
with pliers.
Paper hold front
Screws
Screws
(3) Release the left cartridge hold roller and remove the cartridge guide L (by loosening the screw
and releasing the hook) then pull out feed flat cable 20P.
Screw
Figure 4.22
Note: When installing the paper feed chassis unit, screw the left chassis of this paper feed chassis unit,
set the paper tray, displace the right chassis of this unit up to the paper tray and screw them.
Hook (the rear side)
Cartridge hold roller
Pliers
Figure 4.21
Paper hold rear
Feed flat cable 20P
Screws
Screws
Paper feed chassis unit
Cartridge guide L