Filter
Top Products
Appendix C: Optional Installations and Mode Switch Bank Settings
C-2 8H02-16 User’s Guide
C.2 REMOVING THE CHASSIS COVER
This section describes how to remove the 8H02-16 chassis cover.
To remove the chassis cover, proceed as follows:
1. Disconnect the 8H02-16 from the network as follows:
a. Unplug the power cord from the rear of the 8H02-16 chassis.
DO NOT REMOVE THE COVER FROM THE 8H02-16 WHILE
POWER IS APPLIED TO THE UNIT. HAZARDOUS
VOLTAGES ARE PRESENT AND COULD CAUSE
PERSONAL INJURY AND/OR DAMAGE THE UNIT.
DO NOT POWER UP THE 8H02-16 AGAIN UNTIL THE
COVER AND SCREWS ARE IN PLACE.
DECKEL VON DAS 8H02-16 NICHT ABZIEHEN UNTER
SPANNUNG. GEFAHR FÜR DAS PERSONNAL UND/ODER
DAS GERÄT WEGEN GEFÄHRLICHE SPANNUNGEN
ENSTEHT.
8H02-16 NICHEINSCHALTEN SO LANG DER DECKEL UND
SCHRAUBEN NICHT EINGEBAUT SIND.
NO DEBE DE REMOVER LA TAPA DURENTE QUE ESTE
CONELTADO A LA CORRIENTE, UNA DESCARGA
ELECTRICA LE PUEDE CAUSAR Y PROBOCARLE DAÑOS,
AL IGUAL QUE AL APARATO.
NO ENCHUFE A LA CORRIENTE HASTA QUE LA TAPA Y
LOS TORNILLOS ESTEN EN SU LUGAR.
TURN OFF THE 8H02-16 BY UNPLUGGING THE POWER
CORD FROM THE REAR OF THE CHASSIS.
AM HINTEN DES 8H02-16 STECHEI ABZIEHEN UM AUS ZU
SCHALTEN.
APAGUE EL 8H02-16 DESENCHUFE EL CABLE DE LA
UNIDAD.