Filter
Top Products
Appendix C: Optional Installations and Mode Switch Bank Settings
C-6 8H02-16 User’s Guide
C.4 INSTALLING OPTIONAL FAST ETHERNET
INTERFACE MODULES
Figure C-3 shows the location of the Fast Ethernet Interface Module
connectors on the 8H02-16 board for port slots 15 and 16.
Figure C-3 Fast Ethernet Interface Module Connector Location
To install a Fast Ethernet Interface Module in port slot 15 or 16, proceed
as follows:
1. Remove the chassis cover as described in Section C.2.
2. Remove the coverplate from the port slot where the Fast Ethernet
Interface Module will be installed.
!
CAUTION
The Fast Ethernet Interface Module and the 8H02-16 are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could damage the module or the 8H02-16.
1742-11
FRONT PANEL
8H02-16 TOP VIEW WITHOUT COVER
Fast Ethernet
Interface Modules
Connectors