Filter
Top Products
Chapter 6: Local Management
6-34 8H02-16 User’s Guide
This section explains each field of the Full Duplex Configuration screen.
Operation Mode (Toggle)
Allows the user to set the specified port to transmit and receive data
separately or simultaneously. Set this field to one of the following values:
• STANDARD ENET – The port is running at 10 Mbps (default) and
either transmits data or receives data, but not both at the same time. To
set Ethernet ports for Full Duplex operation, refer to Section 6.12.1.
• FULL DUPLEX – The port transmits and receives data at the same
time (full duplex) and operates at 20 Mbps. To set Ethernet ports for
Full Duplex operation, refer to Section 6.12.1.
Link Status (Read-only)
Indicates whether there is a physical connection from this port to another
10BASE-T device. One of the following values appears:
• Link – There is a 10BASE-T link signal present; there is a valid
physical connection from this port to another 10BASE-T device.
• No Link – No 10BASE-T link signal present; there is no valid physical
connection from this port to another 10BASE-T device.
Port Status (Read-only)
Indicates whether the port was turned on or off administratively. One of
the following values is displayed:
• ENABLED – The port is turned on administratively.
• DISABLED – The port is turned off administratively.
Set All Ports (Toggle)
Ports 1 through 14 can be set all at once to either STANDARD ENET or
FULL DUPLEX from this field.
NOTE
Enabling or disabling ports from the Bridge Configuration
screen is described in Section 6.10.2.