Filter
Top Products
11‑19
Troubleshooting
Message Description Action
LTR Load paper.
The optimum paper size
selected by the Automatic
Paper Selection mode is not
available in the machine.
Load the indicated paper
size into the machine. If you
press (Start) while this
message is displayed, prints
are made with the currently
selected paper size.
When the message
continues to be displayed
even if the indicated paper
size is loaded, set Drawer
Eligibility For APS/ADS in
Common Settings (from the
Additional Functions screen)
for that paper drawer to
[On]. (See “Automatic Paper
Selection/Automatic Drawer
Switching,” on p. 2‑25.)
–
–
No response.
(imageCLASS MF7480/
MF7470 Only)
The server was not running
when you tried to send.
– Check the destination.–
The network connection
was lost when you tried to
send. (Either you could not
connect to the destination
or the connection was
lost before the job could
complete.)
– Check the status of the
network.
–
A TCP/IP error occurred
when you tried to send an
e‑mail or I‑fax.
– Check that the network
cables and connectors are
properly connected.
–
No response from the server.
Check the settings.
(imageCLASS MF7480/
MF7470 Only)
The specified server settings
are incorrect, or the server is
not turned ON. Alternatively,
the machine’s TCP/IP resources
may be low.
Wait for a while, and try
browsing again. If you still fail,
try selecting another server.
Out of resources. Wait for
a moment, then perform
operation again.
(imageCLASS MF7480/
MF7470 Only)
You cannot browse the
network due to a lack of TCP/IP
resources. This may be because
documents have just been
continuously sent or are being
continuously sent through FTP
or Windows (SMB).
Wait for a while, and try
browsing again.