Filter
Top Products
88 Maintenance Chapter 10
Setting The Power Save Timer
Power Save mode is the mode in which the scanning lamp is shut off. You can specify the length
of time until the machine enters the Power Save mode by using the Power Save Timer setting. If
you perform an operation immediately after recovering from Power Save mode, the image may not
be correctly read by the machine. If you use the machine frequently, we recommend that you set
the Power Save Timer to <4 HOURS> or <8 HOURS>.
IMPORTANT
• After recovering from Power Save mode, wait at least one minute before scanning or copying.
• The default setting is <1 HOUR>.
Follow this procedure:
1 Press [Additional Functions].
2 Use [W] or [X] to select <7.POWER SAVE TIMER>.
3 Press [Set].
4 Use [W] or [X] to select the time to switch the machine to Power Save
mode.
–<1 HOUR>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for one hour.
–<4 HOURS>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for four hours.
–<8 HOURS>: Switches the machine to Power Save mode if any key on the operation panel
is not pressed for eight hours.
5 Press [Set].
USER DATA
7.POWER SAVE TIMER
Ex:
POWER SAVE TIMER
1 HOUR