Filter
Top Products
www.axxessid.com
Installation & User Guide
AX200 Installation & User Guide – July 2007
78
Select COM Port
The AX200 software on start-up will automatically scan COM ports 1 to 4, and if found, display
the port found. Consequent start-up of the AX200 software will look at the port found address
only. By selecting auto-detect, the software will scan all ports and find the appropriate COM port.
Manually ports 1 to 16 can be selected if required. Baud rate and parity settings are
automatically configured. The default setting is “Disable”.
Clicking on the advanced button will open the Com Port Advanced Setup screen where you will
be able to generate SNMP messages to be sent to a SNMP manager when an alarm goes off. To
activate the SNMP settings tick the check box next to the “Enable SNMP alarms”. Enter
manager’s specifications including Manager’s name & the IP address on the right hand side.
Agent’s information will be entered on the left. So when an alarm is generated an SNMP
message is automatically sent to the manager. This message will contain the I-box ID number
and IP address, Sensor ID, Alarm description, time and date. You can generate a sample SNMP
message by clicking on the Test button.
In order to access the SNMP Manager Screen
go to the main screen, click on the Tools menu
on the top. Then go to Enable Optional
Software • SNMP Manager. Click on “Start
Manager” button on the top; the application will
automatically search for the available agents
on the network and list their IP addresses on
the left. Click on the appropriate IP address.
Once the alarm is generated the SNMP
message will appear in the in the space on the
bottom.
Multiple/Single Card Format