Filter
Top Products
www.axxessid.com
Installation & User Guide
AX200 Installation & User Guide – July 2007
98
Sensor’s specifications are displayed at the top of the screen. You could specify how frequent
you would like the sensor to take readings and how often you’d like the readings to be reported.
All the reported and unreported data will be stored in the log file and can be accessed via the
report section.
If the Alarm on Fault/Fire is ticked, once there is a fire or fault in the unit, an alarm transaction will
be generated and displayed on he main screen. This message will include the I-box and the
sensor’s name + type and the time of the alarm. The AX200 software now has the ability to send
these alarm messages along with all the necessary information via email.
Isolate
In order to switch on the isolate, click on the advanced button. The output settings are located on
the bottom of the screen. The software will ask you to enter a brief explanation called “permit to
work” before switching on the isolate. The software reports the isolate state by showing a flashing
icon below the controller buttons on the main screen.
Please note that the Isolate is considered an alarm condition so as long as the unit is in isolate
the sensor’s symbol in the environment screen will remain amber, even if all the other alarms
have been cleared!
Once you switch on the isolate the isolate light on the Redetec unit comes on. Please note that
the isolate command from the software overrides the position of the keys switch.