Filter
Top Products
4-3
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01
Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Configuring the WLSE’s Network Information
Configuring the WLSE’s Network Information
Use the setup program to configure the WLSE when you boot it for the first time,
and if you ever have to erase the configuration.
• Press the Backspace or Delete key to delete characters when entering a
response to a prompt.
• You cannot edit a response after you press the Enter key. You can use CLI
commands to change some responses after running setup; see Changing the
Configuration After Running Setup, page 4-6.
• You can exit the setup program in two ways:
–
Press Ctrl-c.
The login prompt appears. Log in as the user setup to rerun the setup
program.
–
Enter no at the final prompt:
Would you like to save this configuration? [yes].
The setup program exits without saving the configuration, then restarts.
See Table 4-2 on page 4-4 and Table 4-3 on page 4-5 for the data you will need to
enter into the setup prompts.
Running the Setup Program
To configure WLSE network information, perform the following steps:
Step 1 Connect a console to the console port:
• For the WLSE 1105, use the serial port on the front panel; do not use the serial
port on the back panel as a console port.
• For the WLSE 1130, the serial/console port is on the back panel.
For more information about connecting a console to the WLSE 1130, see
Connecting Cables, page 3-9.
Step 2 Power on the WLSE.
When the system finishes booting, a login prompt appears on the console.